Lower kitchen cabinets

Now that that ceiling is done I don;t need to get the ladders in here and I can finally start building the kitchen cabinets. Gotta start somewhere! I picked up 11 pallet frames @ a local coffee roaster to use for the case frames. I am comfortable making half lap joints, so I think that is how I am going to continue as I make the case frames.

 I collected many Steve Keene paintings to use for the back panels. This one was too tall, so the caption I glued to the floor. The bottom of the cabinet will be remove-able so I can get to the battery that runs the emergency brakes.

 Cut down the piece of aluminum that I have been using for ages as a cover for the stove, and now it is finally where it was always intended to be! Under the stove!

 I am using pallets from the tops and bottom of can packs from the local coffee roaster. Charlie is saving 11 pallets for me to build out the next two lower cabinet cases: for the kitchen sink and around on either side of the stove.